A social network for Tundra owners
I have the Stainless Toyota Exhaust Finisher but what way does it install?
We have 3 parts:
1) The Big Tip (OOOOHHH SHINY!)
2) Big Adjustable clamp
3) Semi Circle Shim
What is the proper configuration for these? Does the shim go opposite the protruding lip or into the protruding lip? Does the lip go top bottom or side?
I got this one from my father when he replaced his stock exhaust with a After Market one so I didn’t get to see the original config.
If you have one currently installed please have a look and let me know.
Thank You,
Jeremy
Comment
-
Comment by Jason Lancaster on November 12, 2007 at 1:40pm
- LOL. Good post.
-
Comment by Jeremy Breaux on November 9, 2007 at 8:57pm -
I figured it out:
SURVEY SAYS........ The shim goes into the outer lip making a semicircle. Clamp goes over that which, DUH, is also Semicircle shaped. Tighten nut on clamp until snug,
If tail pipe collapses loosen nut, take tip off and go buy you what you really wanted to begin with, a Cat Back System.
© 2010 Created by Jason Lancaster
You need to be a member of TundraNetwork to add comments!
Join TundraNetwork